The project ? 200 Watt Electricity generation through road ramps by using flywheel? looks similar to the normal roads but have ramps in it through which electricity is generated. When a car pass over the ramp the electricity is generated by the module built under the ramp. It will utilize the motion
200 Watt Electricity Generation through Road Ramps by using Flywheel
The project “ 200 Watt Electricity generation through road ramps by using flywheel” looks similar to the normal roads but have ramps in it through which electricity is generated. When a car pass over the ramp the electricity is generated by the module built under the ramp. It will utilize the motion and pressure of vehicle on the roads through the phenomena of converting the kinetic energy into electrical energy. It is a system designed to capture kinetic energy from all vehicles. This device converts the kinetic energy of the vehicles into electric energy. In areas with highly populated traffic such as highways or main roads this device can generate electricity in kilo watts per day.
We will develop a system which will harness the Kinetic Energy of vehicles. In our University, we will install it on the main gate to demonstrate the average power produced per vehicle.
Our Country is facing severe energy crisis and our centralized electricity system is only based on ancient ways of generating. The system cannot fulfill the demand of customers as the number of electricity users are increasing exponentially. Our most rural areas are currently without electricity and the Grid Lines also can’t reach them . So this project will be helpful in a way that it will generate the electricity by the waste Kinetic energy of vehicles and convert it in electrical energy and can produce 400 to 450 watts per hour and it will generate kilo watts energy per day. Our goal is to provide low cost electricity to the far rural areas of our country where the lives of country peoples are badly affected due to energy crisis, although the energy resources are explicitly available. It is beneficial in a way that :
Suitable at parking of multiplexes, toll booths, signals or highways.
| Item Name | Type | No. of Units | Per Unit Cost (in Rs) | Total (in Rs) |
|---|---|---|---|---|
| Bevel Gears | Equipment | 2 | 3000 | 6000 |
| Flywheel | Equipment | 1 | 6000 | 6000 |
| shafts | Equipment | 2 | 1200 | 2400 |
| Dynamo | Equipment | 1 | 15000 | 15000 |
| lock Bearing | Equipment | 1 | 2000 | 2000 |
| ball Bearing | Equipment | 1 | 200 | 200 |
| buck boost ciruit | Equipment | 1 | 800 | 800 |
| arduino | Equipment | 1 | 650 | 650 |
| LCD | Equipment | 1 | 350 | 350 |
| Wires and PCB board | Equipment | 1 | 1000 | 1000 |
| Battery | Equipment | 1 | 12000 | 12000 |
| Invertor | Equipment | 1 | 8000 | 8000 |
| Ramp Structure | Equipment | 1 | 15000 | 15000 |
| Total in (Rs) | 69400 |
The electrical load management systems, which are mostly built on Arduino, have the potent...
Automatic Indoor Air Decontamination System originates from three main observations of our...
According to a survey conducted in Pakistan, 14 percent of Pakistanis suffer from speech d...
To design and construct fire detection and alarm system consist of two or more subsystem(s...
Goal of our project is to create a mobile app which monitor and automate home appliances....