Modeling and control of electric vehicle operated by hybrid energy sources through wireless charging station

Across the globe, governments have been tackling the concerning problem of air-polluting emissions by committing significant resources to improve the eco-friendly environment. however, to achieve the goal of air purification requires both the private and public sectors investment in clean energy tec

2025-06-28 16:34:09 - Adil Khan

Project Title

Modeling and control of electric vehicle operated by hybrid energy sources through wireless charging station

Project Area of Specialization Electrical/Electronic EngineeringProject Summary

Across the globe, governments have been tackling the concerning problem of air-polluting emissions by committing significant resources to improve the eco-friendly environment. however, to achieve the goal of air purification requires both the private and public sectors investment in clean energy technology. It will also need a transition from conventional vehicles to electric vehicles (EVs). The Electrical vehicle (EV) is the best solution to reduce the global warming emission gases. EV technology is becoming trendier in the transportation sector because they consume very less amount of crude oils and are environmentally friendly. The electric vehicles include battery electric vehicles, hybrid electric vehicles and fuel cell electric vehicles.

Hybrid electric vehicles are becoming the major alternative for conventional vehicles. Compared to conventional vehicles, hybrid electric vehicles are remarkable in terms of efficiency, durability and reduced emission capability [1]. As the performance of HEVs improved, researches were conducted to optimize the charging technology simultaneously. Conventional chargers were based on the wired power transmission mechanism, in which the power will be transmitted from the charging station to the EV battery employing wired plugging, it faces several disadvantages like ohmic losses in the transmission cable, higher space requirements for the charging station and the possibility of open circuit and short circuit forced the researchers to find a contactless charging mechanism. Therefore, the Wireless Power Transmission (WPT) Technology was introduced to enable the transmission of electrical energy from a power source to an electrical load across an air gap without interconnecting wires. This technology provides efficient, fast, and low maintenance cost. Microwaves would be used to send electromagnetic radiation from a power source to a receiver.

Project Objectives

The objectives of this thesis project are:

Project Implementation Method Benefits of the Project

Expected Outcome

Value of the Research Work

Technical Details of Final Deliverable

At the completion of this thesis project, Electric Vehicle will be charged through solar cells that it won't affect on its batteries to suffer from overvoltages because of DC-DC Buck converter, Three to Four charging stations will be established to charge the battery cells of vehicle. Moreover, Electric vehicle parameters and life of battery cells can be observed through Matlab, this might give birth to the IoT controlled  Electric vehicle. 

Final Deliverable of the Project HW/SW integrated systemCore Industry Energy Other IndustriesCore Technology Clean TechOther TechnologiesSustainable Development Goals Good Health and Well-Being for People, Affordable and Clean Energy, Life on LandRequired Resources
Item Name Type No. of Units Per Unit Cost (in Rs) Total (in Rs)
Total in (Rs) 78900
Arduino(mega) Equipment415006000
4w4 Smart car kit Equipment220004000
HC 05 Bluetooth module Equipment26001200
L298 motor driver module Equipment34001200
jumper wire Equipment100101000
Arduino(UNO) Equipment28501700
WIRELESS FAST CHARGER Equipment4250010000
RECHAREGEABLE BATTRY CELL Equipment8200016000
SMALL SOLR CELL(DIV KIT) Equipment6420025200
ARDUINO (NANO KIT) Equipment116001600
DC-DC BUCK CONVERTER Equipment110001000
stationary, printing , Miscellaneous 11000010000

More Posts