Wireless power transmission through Rectenna and its utilization.

Project Title

Wireless power transmission through Rectenna and its utilization.

Project Area of Specialization Wearables and ImplantableProject Summary

In this Project we introduce another idea for WPT, through Microwave Power transmission (MPT). In order to reduce the transmission losses, for this process we used a special type of Antenna which named as Rectenna. Rectenna convert Microwave power into DC power which we utilize.

Wireless power Transmission (WPT) is the process of transfer power from one end to another end or from source to the loud without wires. The WPT is also called wircity. The WPT we utilized to charge the Mobile Phone and low power rating device such as Digital camera and Laptop etc.

Project Objectives

1. Eliminate the cord on the ground that make trapping hazards.
2. A necessary step toward consumer wireless power transfer.
3. Allow no wire installation.

1. Used to charge Mobile-Phone, Laptop.
2. It is also used to charge the digital camera.

Project Implementation Method

Methodology of WPT Trough Rectenna:

The research methodology of The WPT we divided into two Parts.

Transmitter:

                 Transmitter Block Diagram.

• Ads software used for simulation of Rectenna.
• 2.4GHz frequency-Band.
• Transmitting Antenna.

Receiver:

In Receiving-side the WPT (RF-signal) is obtained on the Receiving Antenna. By convert the RF received power in to The DC power of about 5V DC. We use the Shottky-Diode for the rectifier purpose.

After rectification we pass the DC voltage through Loss-Pass filter we which remove the High frequency components from the rectifier voltage. Then we connect the DV output to the loud. In the loud we use Mobile Phone charger, for charging of Mobile phone.

The Hardware required For WPT:

• Rectenna
• Rectifier(diode)
• Matching Circuit(Resister , Capacitor and inductor)
• Low-Pass filter (LPS).

Benefits of the Project

binifits of the project are explained in Objective column.

Technical Details of Final Deliverable

technical detail are explained in methodology.

Final Deliverable of the Project HW/SW integrated systemType of Industry IT Technologies Wearables and ImplantablesSustainable Development Goals Industry, Innovation and InfrastructureRequired Resources

Item Name	Type	No. of Units	Per Unit Cost (in Rs)	Total (in Rs)
			Total in (Rs)	43880
substrate	Equipment	2	10000	20000
shortky diode	Equipment	16	80	1280
inductors	Equipment	10	20	200
capacitor	Equipment	10	20	200
sma connector	Equipment	12	1200	14400
chemicals	Equipment	10	600	6000
resistors	Equipment	10	20	200
stand	Equipment	4	400	1600