TO DESIGN THE PI CONTROLLER FOR ENHANCEMENT OF PERFORMANCE OF HYBIRD POWER GENERATION SYSTEM
The Photovoltaic system is the major renewable energy source to produce electricity. The output voltage of a PV is not sufficient enough for better performance of any type of Load devices to improve the output voltage MPPT with Boost Converter along with Per
2025-06-28 16:29:50 - Adil Khan
TO DESIGN THE PI CONTROLLER FOR ENHANCEMENT OF PERFORMANCE OF HYBIRD POWER GENERATION SYSTEM
Project Area of Specialization Electrical/Electronic EngineeringProject SummaryThe Photovoltaic system is the major renewable energy source to produce electricity. The output voltage of a PV is not sufficient enough for better performance of any type of Load devices to improve the output voltage MPPT with Boost Converter along with Perturb and Observe (P&O) algorithm other than this many techniques like Beta method, solar charge controllers with pulse width modulation (PWM), fractional order PID, (FPGA) Field programmable gate array with fuzzy logic, Particle swarm optimization (PSO) are used. In all these methods PV peak power is improved but not properly improved and maximized, to maximize and improve the peak power output PI controller is used also the performance of output voltage shows non-linear curve which can also be improved by using fuzzy logic with PI in future.
Project Objectives- To design and simulate the model of photovoltaic system.
- To enhance the performance of output Voltage using MPPT technique with Boost Converter.
- To design the PI controller for PV
- To analyze the performance of PV with (P&O) .
- Validate the results.
- Make the hardware model of Photovoltaic system with perturb and observe and analyze, compare its results with simulation results.
- Collect the data through literature review.
- First simulate the Photovoltaic model.
- After that simulate the coding of (P&O) .
- Analyze and observe the results.
- And then develop the hardware model.
- Improves the output voltage and current.
- Enhance the performance of PV system.
- Increase the output power.
There are many environmental problems caused due to renewable energy production from fossil fuel, biomass, geothermal energy and nuclear reaction .So it is necessary that an environmental sustainable source of energy must be invented. The solar energy is the most abundant resources and free of cost available on earth. The easy way to convert solar energy to electrical energy is photovoltaic (PV) system
This project is developing simulation and hardware model of photovoltaic system with (P&O) that maximize the output power with PI controller and improves the output voltage.
Final Deliverable of the Project Hardware SystemCore Industry Energy Other Industries Education Core Technology OthersOther Technologies Shared EconomySustainable Development Goals Affordable and Clean Energy, Responsible Consumption and ProductionRequired Resources| Item Name | Type | No. of Units | Per Unit Cost (in Rs) | Total (in Rs) |
|---|---|---|---|---|
| Total in (Rs) | 76000 | |||
| pv panel | Equipment | 1 | 8000 | 8000 |
| arduino uno | Equipment | 2 | 4000 | 8000 |
| boost converter | Equipment | 2 | 3000 | 6000 |
| current sensor | Equipment | 3 | 2000 | 6000 |
| voltage sensor | Equipment | 3 | 2000 | 6000 |
| wifi module | Equipment | 1 | 2500 | 2500 |
| 100W load | Equipment | 2 | 3500 | 7000 |
| battery | Equipment | 1 | 8000 | 8000 |
| display | Equipment | 2 | 2000 | 4000 |
| relay | Equipment | 4 | 2000 | 8000 |
| switches | Equipment | 4 | 1000 | 4000 |
| miscellenous | Miscellaneous | 1 | 8500 | 8500 |