Designing a Data Acquisition System Using Labview
The purpose of this project is to design a data acquisition system using Labview software. In the proposed DAQ we are going to analyze the following parameters e.g 3-phase voltage (oscilloscope) , Phasor analyzer , Frequency Analyzer . All operations will be controlled usin
2025-06-28 16:31:59 - Adil Khan
Designing a Data Acquisition System Using Labview
Project Area of Specialization Electrical/Electronic EngineeringProject SummaryThe purpose of this project is to design a data acquisition system using Labview software.
In the proposed DAQ we are going to analyze the following parameters e.g 3-phase voltage (oscilloscope) , Phasor analyzer , Frequency Analyzer .
All operations will be controlled using myRIO .
CT and PT Sensors will be used for sensing .
Project Objectives- To design a Data Acquisition System based on Graphical User Interface
-
Measurement of different parameters such as 3-phase voltage, Phaser analyzer, Frequency analyzer .
-
Reliable, easy to operate and must be user friendly.
-
Real time data analyzation.
We are basically implementing our project in LabView. LabView is a system-design platform and development environment for a visual programming language from National Instruments. using labView we analyze 3 phase voltage and current with the controller 1900.
Benefits of the Project•Normally high voltages cannot be measured through oscilloscope.
•Labvolt series DAQ systems are very expensive.
Labvolt series data acquisition systems only works through Labvolt EMS software
Technical Details of Final Deliverableusing this project we can easily measure 3 phase voltage, current and frequency and easily analyze phasor diagram. myRIO 1800 will be used as a controller and the sensors are voltage sensor and current sensors.
Final Deliverable of the Project Hardware SystemCore Industry EducationOther IndustriesCore Technology OthersOther TechnologiesSustainable Development Goals Quality Education, Gender Equality, Industry, Innovation and InfrastructureRequired Resources| Item Name | Type | No. of Units | Per Unit Cost (in Rs) | Total (in Rs) |
|---|---|---|---|---|
| Total in (Rs) | 67425 | |||
| myRIO 1900 | Equipment | 1 | 65000 | 65000 |
| Voltage Transformer (step down) | Equipment | 5 | 250 | 1250 |
| Current transformer | Equipment | 5 | 165 | 825 |
| Relay Unit (for Protection) | Equipment | 1 | 350 | 350 |