Automatic Grass cutter (IOT based)
Manual grass cutter robots are available in Pakistan, but they consume alot of time and they need physical assistance at any place. we are going to design an IOT based automatic grass cutter robot which has the ability of water sprinkle and it can be controlled globally using IOT. we would used ardu
2025-06-28 16:30:26 - Adil Khan
Automatic Grass cutter (IOT based)
Project Area of Specialization Internet of ThingsProject SummaryManual grass cutter robots are available in Pakistan, but they consume alot of time and they need physical assistance at any place. we are going to design an IOT based automatic grass cutter robot which has the ability of water sprinkle and it can be controlled globally using IOT. we would used arduino software and board for the designing and programming of robot. This robot take initial command and move automatically through mobile command wirelessly.
Project ObjectivesThe main objectives of project are
- move automatically and cut the grass in specific area.
- controlled globally using IOT
- Battery powered because some grass cutter are based engine and they require diesel.
- Energy efficient and low power consumption.
- cost effective
The implementation of project comprises of following steps
- Literature review of previous work and indicate the short comings of previous work
- Equipment selection for the specific application
- Mathematical Model of project
- circuit designing and implementation
- Circuit simulation on proteus software
- circuit testing on proteus software using arduino programming
- Hardware designing of project
- Hardware testing of project
- Mechanical designing
- mechanical manufacturing
- hardware and software intergeration and testing
The benifits of this project are as follows
- cost effective
- energy efficient
- easy to use
- there is no requirement of physical assistance
- globally control using IOT
The technical detail of final deliverables are as follows
- Literature review of previous work and indicate the short comings of previous work
- Equipment selection for the specific application
- Mathematical Model of project
- circuit designing and implementation
- Circuit simulation on proteus software
- circuit testing on proteus software using arduino programming
- Hardware designing of project
- Hardware testing of project
- Mechanical designing
- mechanical manufacturing
- hardware and software intergeration and testing
| Item Name | Type | No. of Units | Per Unit Cost (in Rs) | Total (in Rs) |
|---|---|---|---|---|
| Total in (Rs) | 70225 | |||
| arduino UNO | Equipment | 3 | 875 | 2625 |
| motors | Equipment | 3 | 4820 | 14460 |
| mechanical structure | Equipment | 1 | 22310 | 22310 |
| tyres | Equipment | 4 | 1950 | 7800 |
| motor driver | Equipment | 3 | 4420 | 13260 |
| resistor , capacitor, inductor etc | Miscellaneous | 1 | 5210 | 5210 |
| wires, gum , soldering wire , paste etc | Miscellaneous | 1 | 4560 | 4560 |